DVGW G 469 PDF

Technical Rule – Code of Practice. DVGW G (A) |June Pressure testing methods for gas transmission/gas distribution. DVGW G – DVGW G Polyethylen gas pipelines with an operating pressure up to and including 10 bar (PE 80, PE and PE-Xa) -. Technical rule [WITHDRAWN] Article is not orderable. DVGW G Compression strength test for pipelines and facilities of gas supply.

Author: Grobei Goltijin
Country: Pacific Islands
Language: English (Spanish)
Genre: History
Published (Last): 6 January 2017
Pages: 443
PDF File Size: 19.62 Mb
ePub File Size: 17.35 Mb
ISBN: 216-1-42171-450-1
Downloads: 27125
Price: Free* [*Free Regsitration Required]
Uploader: Doran

The joints need not be covered by backfill. The pressure test is carried out in a maximum of three steps.

The pressure loss may amount to: Before starting the test, the pipeline must be slowly and evenly filled with water at a rate of about 0. The test sections must be defined so that: Drucken Teilen Xing Twitter.

Hydrostatic testing — CEPS a.s.

The test sections must be defined so that:. The main test is a dvvw of the entire system, and in particular of the watertightness and proper execution and installation of the pipes, fittings, etc. This applies in particular to pipelines with mechanical socket connections.

  CHRISSIE MANBY PDF

The pressure loss may amount to:. There are two basic test methods: It is carried out over a period of 3 hours for pipes up to DN To stabilize the pipeline section when the soil has finally settled and the cement-mortar lining has absorbed sufficient water.

Pressure test ǀ Mannesmann Line Pipe

Pressure tests must be carried out by qualified personnel with the relevant knowledge of pipeline engineering, the execution of pressure tests, 46 measurement techniques and the applicable safety regulations. The pipeline is to be tested over its entire length or, if necessary, in sections.

The pressure test must be carried out in compliance with the requirements laid down in the relevant rules and regulations, e.

Before the pressure test can be carried out, the pipeline must be covered with backfill material so as to avoid shifts in position, which could cause leaks. Each pipeline must be subjected to a pressure test after it has been laid.

  018 TAMMUDITOA 01 05 PDF

Water absorption in the cement-mortar pores may initially cause a drop in pressure even if the pipeline is completely watertight. The water loss method see DVGW Worksheet W can be used as an equivalent alternative to the pressure loss method described above.

For this reason it is advisable to carry out the pressure test over a period of at least 24 hours. Determines the amount of air still in t pipeline. Carry out as specified by the planner Main test: The pressure must be brought back to the test level at regular intervals and in any case after a drop of 0.